1) Lay the ribbon out on a flat surface and lift one on the tail ribbons to revel the narrower pull cords as shown in picture.
2) Run the two narrow pull ribbons between two fingers. The bow will then start to gather against the back of your hand.
Pull bow tails with the pull card ribbon shown between the tail ribbons run the pull cords between your fingers ribbon bow will start to gather against your hand
3) The ribbon will gather into a bow against the back of your hand. Once complete simply tie off the two pull cords to secure the bow and to stop it unravelling.
4) Spread out the ribbon tails to create the desired look as shown below. Your bow is now complete.
Finished pull bow
Comments (10)