Browse Categories
Mailing Lists
Solution Graphics
       
     DIY Gingham Baby Shower Favor Box
 
Diy baby shower favor box
 

Supplies:

 
 

Gingham Butter Mints

0.5" White Mini Pastel Paper Rose 

Hot Melt Glue Gun with Glue Sticks

 

Directions:

1.     Lay out all the materials you will need for this project.

DIY baby shower favor box process1

2.     Open one of the Clear Plastic Baby Cubes.  It should open from the top.

3.     Place about 4 to 5 pieces of Gingham Butter Mints inside the box.

DIY baby shower favor box process2

4.    Close the box by pressing it firmly into place.

5.    Grab the 1/4" Gingham Pull Bow Ribbon.  Measure approximately 1 yard (3 Feet).  There is a white string in the middle of the bow.  Firmly grasp the string and pull the rest of the bow to start creating the loops as seen on the bow.  It should produce about 14 loops.  You should now have a beautiful bow.  Cut the bow from the ribbon and tie off the  two white string (one from each end) to hold the bow in place.

DIY baby shower favor process 3  DIY baby shower favor process4

DIY baby shower favor box process 5

6.     Now cut approximately 16” inches of ribbon to tie around the plastic box.  Place the string underneath the box leaving one end approximately 4” longer than the top of the box.  Then loop the string about to get the ribbon started along the other sides of the box.

DIY baby shower favor box process 6

7.     Grab the longer part of the ribbon (not the 4” slack of ribbon) and loop it around the other sides of the box.

DIY baby shower favor box process 7

8.     Loop the ribbon around the top of the box and tie it off.

DIY baby shower favor box process 8  DIY baby shower favor box process 9

9.     Now with the glue gun.  Squeeze a small dab of glue to the bottom of the Gingham Bow Ribbon you created earlier.  Place it on top of the box in the middle of ribbon where you tied off the box.  Press surfaces together within 15 seconds. CAUTION: Hot melt glue gets hot!

DIY baby shower favor box process 10

10.  Grab the package of 0.5” mini Pastel Paper Rose and cut off one of the flower (but be sure to leave about ¼” inch of stem).  Fold the stem back against the flower to make it flush with the flower.  Again grab the glue gun and place a small dab of glue on the back of the flower.  Place the flower in the middle of the Gingham Bow Ribbon and press surfaces together within 15 seconds and wait for the glue to dry.   CAUTION: Hot melt glue gets hot!

DIY baby shower favor box process 12

Congratulations and best of luck to you and your new born.

 

 

Search
Shopping Cart
Your cart is empty.

 

 
Dear Customer,
Local pick up is free, but your order must a minimum of $50.