Browse Categories
Mailing Lists
Solution Graphics
       
How to make a Jordan Almond Flower Favor
jordan almond flower favor
 
Supplies:
jordan almond flower favor diy
 
 
Directions:
1.     Pull and open  the  Flower Petal Almond Holder Ribbon and place one almond into each pedal for a total of five pedals.
 
diy jordan almond flower favor
2.     Firmly grasp the string and pull the string tight on the Flower Petal Almond Holder Ribbon to form a five pedal flower.
 
diy jordan almond flower favor 3
 
3.      Cut the fifth petal from the ribbon and tie off the two white string (one from each end) to hold the flower in place.
 
jordan almond flower favor process 4  jordan almond flower favor process5
 
 

4.     Next take the roll of Ivory 1 1/2" Organza Capia Pull Bow Ribbon, firmly grasp the string and pull the string tight (about 12" inches of ribbon) to form a circular pattern flower.  Tie off the  two white string (one from each end) to hold the bow in place.

 
 
 
 
5.     Now place the Flower Petal Almond Holder Ribbon on a flat surface.  Warm up the glue gun. Squeezed a small dab of glue to the center of the Flower Petal Almond Holder Ribbon and place  the Ivory 1 1/2" Organza Capia Pull Bow Ribbon on top of the Flower Petal Almond Holder Ribbon .  Try to center the two flowers.  Press surfaces together within 15 seconds. CAUTION: Hot melt glue gets hot!
 
 
6.     Take the Personalized ribbon and form a small loop at the top.  Again Squeezed a small dab of glue where the ribbon meets and press surfaces together within 15 seconds. CAUTION: Hot melt glue gets hot!
 
  
7.     Now take the two flowers that you previous glued together Squeezed a small dab of glue to the center of the top flower (Ivory 1 1/2" Organza Capia Pull Bow Ribbon), then place the Personalized ribbon on top of the top flower and press surfaces together within 15 seconds. Remember to center the personalized ribbon.CAUTION: Hot melt glue gets hot!
 
 
8.     Grab the package of Ivory Organza & Satin Rose Bud With Pearl and cut off one of the flower (but be sure to leave about ¼” inch of stem).  Fold the stem back against the flower to make it flush with the flower.  Again grab the glue gun and place a small dab of glue on the back of the flower.  Place the flower in the middle of the personalized ribbon and press surfaces together within 15 seconds. CAUTION: Hot melt glue gets hot!
 
 
 
Congratulation! Your elegant and unique Jordan Almond Flower Favor is done!
 
Search
Shopping Cart
Your cart is empty.

 

 
Dear Customer,
Local pick up is free, but your order must a minimum of $50.